动态视距
无需再手动调整渲染距离。Dynamic View Distance 会实时监测你的帧率,并自动调整视距——为你提供当前电脑能流畅运行的最佳视野。
工作原理
该模组定期测量你的 FPS,并将其与两个阈值进行比较:
- FPS 过低 → 每次减少一个区块的渲染距离,直到运行恢复流畅。
- FPS 足够高 → 每次增加一个区块的渲染距离,以展示更多世界内容。
- FPS 处于理想区间 → 保持现状不变。
通过这种方式,该模组会自动在视野范围和性能之间找到最佳平衡点——无论你是穿越简单的平原生物群系,还是站在复杂的红石基地中。
功能特性
- 根据当前帧率自动调整渲染距离
- 自定义游戏内设置菜单——无需 Cloth Config 或 ModMenu
- 自由配置限制: 最小和最大视距、下限和上限 FPS 阈值
- 冷却系统防止视距频繁来回波动
- 可调节的检查间隔——即 FPS 测量的频率
- 设置保存为简单的 JSON 文件,并在游戏会话间持久保留
使用方法
在游戏中按 V 打开设置菜单(该按键可在 选项 → 控制 中重新绑定)。你可以在其中使用滑块调整以下设置:
| 设置项 |
作用 |
| 模组启用 |
开启/关闭自动调整 |
| 下限 FPS 阈值 |
低于此值时,视距将减小 |
| 上限 FPS 阈值 |
高于此值时,视距将增大 |
| 最小区块数 |
视距不会低于此值 |
| 最大区块数 |
视距不会高于此值 |
| 检查间隔 |
FPS 测量的频率(以刻为单位) |
| 冷却时间 |
每次更改后的暂停时间(以秒为单位) |
安装方法
- 为 Minecraft 26.1.2 安装 Fabric Loader
- 下载 Fabric API 并将其放入
mods 文件夹
- 将 Dynamic View Distance 也放入
mods 文件夹
- 启动游戏——完成!
注意事项
- 这是一个客户端模组——它可以在任何服务器上运行,即使服务器未安装该模组。
- 需要 Fabric API。
- 专为 Minecraft 26.1.2 构建。
Dynamic View Distance
No more manually fiddling with your render distance. Dynamic View
Distance monitors your framerate in real time and adjusts the view
distance automatically — giving you the best possible view your PC can
currently run smoothly.
How it works
The mod measures your FPS at regular intervals and compares it against two
thresholds:
- FPS too low → render distance is decreased by one chunk until things
run smoothly again.
- FPS high enough → render distance is increased by one chunk to show
more of the world.
- FPS in the sweet spot → everything stays as it is.
This way the mod finds the optimal balance between view range and
performance on its own — whether you're running across a simple plains
biome or standing in a complex redstone base.
Features
- Automatic adjustment of render distance based on your current
framerate
- Custom in-game settings menu — no Cloth Config or ModMenu required
- Freely configurable limits: minimum and maximum view distance, lower
and upper FPS thresholds
- Cooldown system prevents the view distance from constantly flickering
back and forth
- Adjustable check interval — how often your FPS is measured
- Settings are saved to a simple JSON file and persist across game
sessions
How to use
Press V in-game to open the settings menu (the key can be rebound under
Options → Controls). There you can adjust the following with sliders:
| Setting |
What it does |
| Mod enabled |
Turns automatic adjustment on/off |
| Lower FPS threshold |
Below this, view distance is decreased |
| Upper FPS threshold |
Above this, view distance is increased |
| Minimum chunks |
View distance never goes below this value |
| Maximum chunks |
View distance never goes above this value |
| Check interval |
How often FPS is measured (in ticks) |
| Cooldown |
Pause after each change (in seconds) |
Installation
- Install Fabric Loader for Minecraft 26.1.2
- Download Fabric API and place it in your
mods folder
- Place Dynamic View Distance in your
mods folder as well
- Launch the game — done!
Notes
- This is a client-side mod — it works on any server, even ones that
don't have the mod installed.
- Requires Fabric API.
- Built for Minecraft 26.1.2.
评论 0
登录后参与评分
还没有评论,来抢沙发吧