要建造你的车站,首先需要制作车站建造器方块。
放置该方块后,将在其位置生成一个车站。如果再次放置该方块,将在第一个和第二个车站之间建立铁路,实现基地间的快速旅行。你也可以在两个以上的车站之间创建连接路线。
要使车站建造器方块连接到前一个车站,它必须处于相同的 Y 坐标,且 X 和 Z 坐标至少相距 20 格。根据相连车站的方向,部分旧轨道可能会损坏;你可以手动修复这些区段。
如果你希望断开与旧车站的连接并从零开始建立新的车站网络,你需要重新制作车站建造器方块。每次制作车站建造器都会重置你与旧车站网络的连接。因此,在建造初始车站并开始组网之前,请确保制作了足够的车站建造器方块。
当你制作车站建造器方块时,你与旧车站网络的连接将被重置,从而允许你在指定的 Y 坐标设置车站以启动新网络。
右键点击列车员可以召唤 Blocktrain(冷却时间 120 秒)
我没有为建造铁路的距离设置上限。不过,建议你根据电脑性能保持距离较低。当我使用 8GB 内存进行测试时,约 4000 格的距离会导致问题并存在崩溃风险,请务必小心。
To create your station; first, craft the Station Builder block.
When you place this block, a station will be created at that location. If you place this block a second time, a railway will be established between the first and second stations, allowing for fast travel between your bases. You can also create connecting routes between more than two stations.
For the Station Builder block to connect to the previous station, it must be at the same Y-coordinate, and the X and Z coordinates must be at least 20 blocks apart. Depending on the direction of the connected stations, some old tracks may become damaged; you can manually repair these sections.
If you wish to disconnect from old stations and start a new station network from scratch, you will need to craft the Station Builder block again. Each time you craft a Station Builder, it resets your connection to the old station network. Therefore, ensure you craft enough Station Builder blocks before creating your initial station and starting your network.
When you craft a Station Builder block, your connection to the old station network is reset, allowing you to set up a station at your desired Y-coordinate to start a new network.
Conductor can spawn Blocktrain when you right click on him (cooldown 120 second)
I haven't set a limit on the distance for creating railway. However, I recommend keeping this distance low depending on your computer's power. When I tested with 8GB of RAM, a distance of about 4000 blocks caused issues and posed a crash risk, so be careful.
评论 0
登录后参与评分
还没有评论,来抢沙发吧